Ajman workshop · UAE-wide install
Steel structures — beams, frames and buildings, cut to the drawing.
If the pieces do not fit, someone else fabricated them. Teer Al Madina Workshop does shop drawings, cuts and welds in Ajman, and erects on site across the UAE — mezzanines, canopies, building frames and one-off structures that have to line up with the slab you already poured.
- Mezzanines, canopies and building frames
- Shop drawings before we cut
- On-site erection and alignment
Mezzanines, canopies and building frames
Typical jobs: a mezzanine over a warehouse floor, a canopy on a villa or showroom, a frame that other trades will clad. We work from your drawing, a sketch, or a site measure. If the job needs proper shop drawings before we cut, we say so in the quote — not after the steel is on the truck.
One workshop from drawing to erection
Splitting design, fabrication and install is how spans get ‘adjusted’ on site for two days. Our Ajman shop cuts to the same numbers the crew will erect in Dubai, Sharjah or Abu Dhabi. Alignment, anchors and a snag-list are part of handover, not extras.
Specified for UAE loads
Sections are sized for span and wind, not copied from a lighter climate. Surface prep and coatings are chosen for sun and, where needed, coastal air. If you already have an engineer’s drawing, we fabricate to it. If you do not, we tell you what we can take in-house and what still needs a stamp.
Field photos
Steel Structures we have already installed
UAE coverage
Fabricated in Ajman. Installed from Abu Dhabi to Fujairah.
Steel Structures jobs are quoted with travel in the price — Dubai, Sharjah, the Northern Emirates and Abu Dhabi included.
Ajman
Workshop & HQ — fastest site visits
Sharjah
Daily installation crews
Dubai
Villas, compounds & commercial
Umm Al Quwain
Farms, yards & warehouses
Ras Al Khaimah
Coastal & industrial jobs
Fujairah
East-coast installation
Abu Dhabi
Quoted with travel in the price
